AC Load Monitor Cincinnati OH

A simple circuit monitors the elapsed time over which a line-connected ac load energizes. You can then access the elapsed-time count over a standard one-wire protocol.

Local Companies

Computer Products Corporation
(513) 221-0600
2106 Florence Avenue
Cincinnati, OH
Martin & Associates
(513) 772-7284
10385 Spartan Drive
Cincinnati, OH
TechSoft Systems Inc.
(513) 772-5010
10296 Springfield Pike
Cincinnati, OH
Information Alternatives Inc.
(513) 793-2929
2943 Riverside Drive
Cincinnati, OH
MobileTEK Consulting LLC
(513) 731-6800
1776 Mentor Avenue
Cincinnati, OH
LUCRUM Inc.
(513) 241-5949
312 Plum Street
Cincinnati, OH
Rippe & Kingston Systems
(513) 241-1375
1077 Celestial Street
Cincinnati, OH
CSC Consulting
(513) 381-4440
255 East Fifth Street
Cincinnati, OH
Resolvit
(513) 619-5900
895 Central Ave
Cincinnati, OH
Netburg Consulting Services
(513) 247-9701
2692 Madison Road
Cincinnati, OH

 

provided by: EDN

A simple circuit monitors the elapsed time over which a line-connected ac load energizes (). You can then access the elapsed-time count over a standard one-wire protocol. When you energize the ac load, the optoisolator provides pulses at the ac-line frequency to the input of the one-wire counter, a DS2423 IC. Thus, the counter continuously increments whenever you energize the load. Resistors R1 and R2 limit the current, and diode D1 protects the optoisolator from reverse-polarity voltages during the negative half of the line cycle.

As an example, the circuit can monitor the duration of operating intervals for a 240V-ac well pump, thereby giving an indirect measure of the amount of water the well pumps and the approximate amount of power it consumes. The one-wire master counter-a Linux-based PC, for example-reads the elapsed count once per minute. Any change in the count from one reading to the next indicates that the pump is energized and running, and you calculate the length of time in seconds by simply taking the difference in counter values divided by the line frequency-60 Hz, in this case. The time in seconds equals the new count minus the old count divided by 60 Hz.

The circuit can monitor a water heater, a furnace, an air-conditioning unit, or any other ac-connected load. You may need to adjust the R1 and R2 values to accommodate line voltages other than 240V ac or the characteristics of other optoisolators. You can also monitor two independent loads by attaching a second optoisolator circuit to the Counter B input of a single DS2423.



author: Michael Petersen, Maxim Integrated Products, Sunnyvale, CA

EDN. Copyright © 2007 Reed Business Information, a division of Reed Elsevier Inc. All rights reserved.

Featured Local Company

Computer Products Corporation

(513) 221-0600
2106 Florence Avenue
Cincinnati, OH