CCNA, CCENT, CCNP Test' Tips Oakland CA

This article lists some questions on static routing, the OSI model, IP version 6, and other topics to make you victory in CCNA, CCENT, and CCNP certification exam.

Local Companies

Alternative Futures
(510) 287-5664
4909 Tidewater Ave
Oakland, CA
First In Emergency Response Training LLC
(510) 282-7663
200 Stantonville Dr.
Oakland, CA
Bob Garner MS MA Ncc
(510) 652-2467
3873 Piedmont Ave
Oakland, CA
Bonnie Bell
(510) 763-5671
1111 Broadway
Oakland, CA
Institute for OneWorld Health
(415) 421-4700
50 California St., Ste. 500
San Francisco, CA
San Francisco Vocational Services
(415) 512-9500
814 Mission St., Ste. 600
San Francisco, CA
The Art Institute of California - San Francisco
(415) 276-4019
1170 Market St.
San Francisco, CA
Gold Group
(510) 777-0900
Oakland, CA
Officeteam
(510) 839-0539
1999 Harrison St Ste 1100
Oakland, CA
Diversified Personnel
(510) 451-4175
505 14th St Ste 850
Oakland, CA

Here are some questions on static routing, the OSI model, IP version 6, and other topics to help prepare you for CCNA, CCENT, and CCNP certification exam success! Network+ candidates, I didn’t leave you out!

CCNA Certification:

What character or combination of characters indicates a statically configured default route?

Answer: An "S*" next to a route indicates that it is a default static route. If there were no asterisk, the route type indicated would be a static route – but not a default static route.

CCENT Certification / Network+ Certification Question:

Which one of the following networking terms is not associated with the same OSI layer as the others?

A. router

B. packet

C. TCP

D. IP

Answer: C. TCP runs at the Transport layer of the OSI model. The other three terms are associated with the Network layer. The Network layer is sometimes referred to as the “routing layer”.

CCNP Certification / BSCI Exam:

If an IPv6 address begins with "FF", what kind of address is it?

A. broadcast

B. unicast

C. anycast

D. multicast

Answer: D. Any IPv6 address beginning with "FF" is a multicast. IPv6 does not use broadcasts.

CCNP Certification / BCMSN Exam:

You've configured an Etherchannel and note that the trunk has gone down. You check the interfaces on one switch and note that two are "err-disabled". The corresponding ports on the other switch are not. What should you do?

A. Nothing - that's the normal and desired behavior.

B. Shut and reopen the err-disabled interfaces.

C. Shut and reopen the non-err-disabled interfaces.

D. Use the err-abled command on the err-disabled interfaces.

Answer: B. After finishing the config, shut and reopen the err-disabled interfaces. If the configuration is correct, that will do the trick. This is common when you configure all of the ports on one switch and then start configuring the other switch, rather than going back and forth between the appropriate ports on the switches.

See you soon with more CCNA, Network+, CCNP, and CCENT questions!

About the Author:

Chris Bryant, CCIE #12933, is the owner of The Bryant Advantage (http://www.thebryantadvantage.com ), home of free CCNA and CCNP tutorials, and The Ultimate CCNA and CCNP Study Packages.

For free daily CCNA, CCNP, CCENT, Network+, Security+, and A+ questions, just visit the website and sign up for the daily newsletter!

Article Source: thePhantomWriters Article Submission Service

Featured Local Company

Alternative Futures

(510) 287-5664
4909 Tidewater Ave
Oakland, CA

Related Local Event
Alternative Press Expo (APE 2009)
Dates: 10/17/2009 - 10/18/2009
Location: Concourse Exhibition Center, San Francisco
San Francisco, CA
View Details