CMOS 555 Timer Drive San Jose CA

provided by: EDN

Using a CMOS 555 timer and a single NPN transistor, you can drive as many as seven LEDs using a minimal amount of voltage and power from a single NiMH (nickel-metal-hydride) AA cell. The circuit works by creating much higher-voltage pulses than the voltage for powering the circuit by pulsing a high-Q power inductor. The circuit creates voltage pulses of 23V using a 1.25V NiMH cell with seven connected LEDs.

The circuit uses a CMOS timer because it functions on low voltages-in this case, as low as 1V. A single white LED rated at 9300 mcd maintains its brilliance down to this low voltage. The circuit works for 192 hours using a 2000-mAHr-rated NiMH cell. The output of the timer is a 4.5-µsec pulse repeating at a 222-kHz rate. Although you can use the circuit to power any LED, it works best using high-brightness, high-power LEDs rated at 3000 mcd or higher. Obviously, the higher the millicandela rating, the brighter the LED will appear.

You can connect the LEDs in parallel if their forward voltages match; otherwise, the LED with the lowest forward voltage will dim out the other LEDs. Using the parallel connection, all LEDs will glow with equal brightness if their forward voltages match. Adding LEDs does not increase the current drawn from the battery but reduces the brilliance of all of the connected LEDs.

The advantage of connecting the LEDs in series-which is possible because of the high pulse voltage they produce-is equal brilliance of all LEDs, regardless of their individual forward-voltage drops and millicandela ratings. Each additional LED decreases additional voltage and lowers the resulting current into the series string of LEDs, lowering their brilliance. Using seven LEDs with a single 1.25V cell draws a current of only 8 mA. By adding a 1.25V cell to the power input, the LEDs become so brilliant that it is difficult to look at them. With a 2.5V supply, the peak voltage pulses increase to 70V with no connected LEDs. With the LEDs connected, the output voltage peaks at 25V. Current draw at 2.5V is 20 mA.

author: Chuck Irwin, Hendersonville, NC

EDN. Copyright © 2008 Reed Business Information, a division of Reed Elsevier Inc. All rights reserved.

Renewable Power Solutions Inc

Solar and wind power design, Engineering, acquisition and installations

408-998-7400
2029 O' Toole Ave
San Jose, CA
www.rps-solar.com

Renewable Power Solutions, Inc.is based in San Jose CA, we provide the best solar electric solution for the future.

Experience.

We have 10+ years of experience in the alternative energy industry using current technologies and state of the art techniques to ensure the best possible solar electric system to meet the needs of our customers.

Our Commitment to You

Power Solutions' commitment to the public is to design and install the solar electric system that best suits your family or business needs. By using our 10 years of experience in the alternative energy industry, current technologies and state of the art techniques we will ensure the best possible solar electric system for you.

Our Principals

We only represent manufacturers that have proven to have excellent customer service, the most reliable products and the least environmental impact during manufacturing. Our 100% customer satisfaction rating is our most important certification. We will not sacrifice it by representing manufacturers that do not share our high standards for sustainability and customer satisfaction.

Our Solution

We would like for everyone to be energy independent and that includes you. Our solution will be presented to you in simple fashion; our engineering team is not allowed to do proposals. We warranty the simplicity of our proposal to make sense environmentally and economically. Your next door neighbors solutions is not necessary the right solution for you. We provide you with one on one attention from the initial visit to the last one.