Grady-White Gulfstream 232 Walkaround Chapel Hill NC

The Grady-White Gulfstream 232 Walkaround is a good looking, nicely proportioned family fishing boat, one of six walkaround models made by the builder. Either twin (usually 150s) or single outboard power is available.

Local Companies

American Marine & Sail Supply Inc
(919) 404-1550
1310 Old US 264 Hwy
Zebulon, NC
Ingram Marine Center
(704) 982-4327
1439 E Main St
Albemarle, NC
Pamlico Marine & Sports
(252) 637-1717
2601 US Highway 70 E
New Bern, NC
Blue Water Yacht Sales
(252) 473-2860
Manteo Cswy
Manteo, NC
Marine Mart
(910) 457-6350
4711 Long Beach Rd SE
Southport, NC
Overby Marine Sales & Service
(252) 438-5338
480 Bobbitt St
Henderson, NC
Foothills Marine and Sports Shop
(828) 439-9022
1331 Nc 181
Morganton, NC
Boat Dock Beach Club the
(336) 859-3625
339 N Shore Dr
Denton, NC
Couick's Marine
(704) 843-2155
3913 Providence Rd S
Waxhaw, NC
Thunder Marine
(704) 663-3330
110A Robinson Rd # 150
Mooresville, NC

Model Introduction
The Grady-White Gulfstream 232 Walkaround is a good looking, nicely proportioned family fishing boat, one of six walkaround models made by the builder. Either twin (usually 150s) or single outboard power is available. The boat has a small but surprisingly accommodating cabin, a protected helm area with room for GPS and radar, and a large cockpit laid out and equipped for serious fishing. The 232 will appeal to the family that likes to fish as well as spend an occasional overnighter and it will prove equally adept at pulling boarders and tubers or just cruising around. The 232 is the smallest Grady-White model, with a beam of over 8 ft. 6 in., so a permit will be needed to trailer it in most states. The extra 15 in. of beam (compared to Grady's 8-ft. wide 22-ft. walkaround model) makes a big difference in terms of elbow room, though, especially in the helm area between the two seats.

Construction
The Grady-White Gulfstream 232 Walkaround has a solid fiberglass hull bottom and balsa coring on the sides with a supporting stringer and bulkhead system of pressure treated plywood (which comes with a lifetime warranty) encapsulated in fiberglass. Limberholes are cut through solid glass to prevent water absorption into the core. Plywood is used to core the transom, which is also supported by aluminum bracing, and the decks and hull-to-deck joint are sealed with a gasket and sealant and fastened with a mix of stainless screws and rivets. Foam injected in the voids between the hull and deck liner makes the boat unsinkable.

Click here to read the rest of the article at JDPower.com