Grady-White Gulfstream 232 Walkaround DuBois PA

The Grady-White Gulfstream 232 Walkaround is a good looking, nicely proportioned family fishing boat, one of six walkaround models made by the builder. Either twin (usually 150s) or single outboard power is available.

Local Companies

Boat Fish Fun Shop
(724) 547-9499
RR 6
Mount Pleasant, PA
Lancaster County Marine Inc
(717) 626-1121
RR 272
Akron, PA
Top Water Marine Inc
(717) 944-3780
2101 E Harrisburg Pike
Middletown, PA
Jlc Marine Inc
(717) 367-6838
385 Hershey Rd
Elizabethtown, PA
Bob Warren & Associates Marine
(724) 285-5503
Butler, PA
Cycle City
(610) 356-2662
2555 W Chester Pike
Broomall, PA
Boat Shop the
(570) 226-4062
RR 507
Tafton, PA
Pocono Boat House
(570) 646-4107
RR 940
Pocono Lake, PA
Capri Marina
(570) 226-3819
Off 590 East W
Lakeville, PA
Reading Boat Works
(610) 926-4739
1084 Cedar Hill Dr
Reading, PA

Model Introduction
The Grady-White Gulfstream 232 Walkaround is a good looking, nicely proportioned family fishing boat, one of six walkaround models made by the builder. Either twin (usually 150s) or single outboard power is available. The boat has a small but surprisingly accommodating cabin, a protected helm area with room for GPS and radar, and a large cockpit laid out and equipped for serious fishing. The 232 will appeal to the family that likes to fish as well as spend an occasional overnighter and it will prove equally adept at pulling boarders and tubers or just cruising around. The 232 is the smallest Grady-White model, with a beam of over 8 ft. 6 in., so a permit will be needed to trailer it in most states. The extra 15 in. of beam (compared to Grady's 8-ft. wide 22-ft. walkaround model) makes a big difference in terms of elbow room, though, especially in the helm area between the two seats.

Construction
The Grady-White Gulfstream 232 Walkaround has a solid fiberglass hull bottom and balsa coring on the sides with a supporting stringer and bulkhead system of pressure treated plywood (which comes with a lifetime warranty) encapsulated in fiberglass. Limberholes are cut through solid glass to prevent water absorption into the core. Plywood is used to core the transom, which is also supported by aluminum bracing, and the decks and hull-to-deck joint are sealed with a gasket and sealant and fastened with a mix of stainless screws and rivets. Foam injected in the voids between the hull and deck liner makes the boat unsinkable.

Click here to read the rest of the article at JDPower.com

Featured Local Company

Rcr Yachts Of Erie Inc

(814) 455-6800
960 W Bayfront Pkwy
Erie, PA